18
To detach the hose connectors from the main base, turn the connectors clockwise until it stops and then pull it
away. To assemble the hose connector to the main base, reverse the steps to finish the assembly.
Assembling Dome Cover to Main Base
NOTE: Start this assembly after finishing all hose connections.
There are 4 tabs on dome cover and 4 slots on the solar heater base. Push the tab into the slot to secure the
dome cover on the heater base.
Warning!
-
Don’t hold the dome cover to move the whole unit.
Connecting the Solar Heater to the Pool
Warning!
-
Before beginning to connect this solar heater to your pool, make sure your pool water outlet and
return inlet are closed and already connected with hoses. Refer to your pool manual or consult your
pool dealer for proper instructions.
-
Turn off the pump before following installation
1. For pools using hose connection of Ø 32 mm (1¼"
)
/ Ø 38 mm (1½"
)
a)
Detach the pool return hose from your pump/filter.
b)
For soft hose of Ø 32mm (1¼"), directly slide the hose to the hose connectors as far it can go. Use the
hose clamp to secure the hose connection.
c)
For soft hose of Ø38mm (1½"), use either long hose provided or another soft hose in same diameter to
connect the pump/filter and middle hose connector. Firstly, insert the hose reducer inside of cuff of long
hose and slide it onto the hose connector as far as it can go. Use hose clamp to secure the hose.
