Comfee CLC27N3AWW, Руководство пользователя, Страница: 7 / 19

P.11 P.12
Installation Instructions
Install inlet pipe Dispose the packing materials
The packing materials of this machine may be dangerous to kids. Please dispose them
properly and avoid easy access by kids or pets. Please dispose the related packing materials
according to the relevant local regulations.
Remove transport bolts and foam
Before using this washing machine, transport bolts
must be removed from the backside of
this machine. Please take the following steps to
remove the bolts:
1.Loosen all bolts with 7/16″ socket to remove bolt 13mm.
2.Cover the holes with transport hole plugs.
3.Keep the transport bolts properly for future use.
Make sure the small triangle foam is removed with the
bottom one together. If not, lay the unit down with side
surface, then remove the small foam from the bottom of
the unit manually.
Select the location
Before installing the washing machine, the location characterized as follows shall be
selected:
- Rigid, dry, and level surface (if not level, please make it level with reference to the
following figure “Adjust Leg”)
- Sufficient ventilation
- Room temperature is above 0
℃
- Keep far away from the heat sources such as coal or gas.
Make sure that the washing machine is not on the power cord.
Do not install the washing machine on the carpet floor. -
-
Connect inlet pipe
Connect the inlet pipe as indicated in the figure.
For the model which has hot valve, please connect
the hot vale to hot water tap.
H
C
1.Connect the elbow to tap and fasten it
clockwise.
2.Connect the other end of inlet pipe to the inlet
valve at the backside of washing machine and
fasten the pipe tightly clockwise.
Note: Please use a standard tap. If there is any leakage after connection, repeat the steps
to connect the inlet pipe.
Drain system options
A
Capacity can be no less than 17 gal.
(
64 L
)
per minute
.
The top of the standpipe must be at least 60cm(23.6") high and
no higher than 100cm (39.4") from the bottom of the washer
.
Floor drain system
(
view D
)
.The floor drain system requires
a siphon break that may be purchased separately
.
The siphon break must be a minimum of 28"(710 mm) from the
bottom of the washer
.
Additional hoses might be needed
.
Min 60(23.6")
Max 100(39.4")
B
Laundry tub drain system
(
view C
)
The laundry tub needs a minimum 20 gal
.(
76 L
)
capacity
.
The top of the laundry tub must be
at least 60cm(23.6") above the foor
.
M
in
.6
0
cm
M
a
x.
1
0
0
cm
C
28 " min .
( 710 mm )
D
Standpipe drain system
-
wall or floor
(
views A
&
B
)
The standpipe drain requires a minimum diameter
standpipe of 2
"
(50 mm).
Installation Instructions