Comelit Icona Manager, Техническое руководство

Страница: 13 / 17

13
Generic actuator, coded actuator
Coded actuator : button programming
Generic actuator : button programming
1. Take note of the S1 DIP-switch settings.
2. To enter programming mode, set S2 DIP-switch 6 to ON.
» the LED flashes
S2
3. Refer to the table “Basic configuration" to identify a DIP-switch combination in which the actuator function (ACT)
corresponding to the button you want to program appears, then set the S2 DIP-switches.
4. Set all the S1 DIP-switches to the ON position.
S1
5. Press and release the button to be associated with the function.
» Correct procedure indication: the LED flashes for a few seconds and a confirmation tone sounds.
6. Exit programming mode by setting S2 DIP-switch 6 to OFF.
» LED switches off
S2
7. Set S2 DIP-switches 1-2-3-4 to ON.
8. Return S1 DIP-switches to the original combination.
1. Take note of the S1 DIP-switch settings.
2. To enter programming mode, set S2 DIP-switch 6 to ON.
» the LED flashes
S2
3. Refer to the table “Basic configuration" to identify a DIP-switch combination in which the actuator function (ACT)
corresponding to the button you want to program appears, then set the S2 DIP-switches.
4. Set the S1 DIP-switches with the desired code, according to “Addressing table" on page 17
5. Press and release the button to be associated with the function.
» Correct procedure indication : the LED flashes for a few seconds and a confirmation tone sounds
6. Exit programming mode by setting S2 DIP-switch 6 to OFF.
» LED switches off
S2
7. Set S2 DIP-switches 1-2-3-4 to ON.
8. Return S1 DIP-switches to the original combination.