20
Operating third-party devices with functions
that can be activated via URL
This mode can also be used to operate third-party devices
with functions that can be activated via URL. This means it
is possible to control devices with different protocols. This
function therefore makes it possible to integrate any home
automation system, even from third parties, to control gates or
an external light, to activate a scenario, etc.
• Art. 6741W (/BM) must be connected to the
internet in order to use this function!
• Art. 6741W (/BM) must be paired with the
Comelit app with version 5.6.0 or higher!
Carry out the steps listed below:
ON
1 2 3 4
6 7
5
8
S2
1.
Set S2 DIP-switches
1-2-3-4 on the rear of
the door entry monitor
to ON, as shown in the
figure.
2.
From the door entry
monitor display:
- Press the menu button, select Setup and confirm
- Select the option
Button configuration
- Select the key to be associated with the function
- Configure the button by selecting “Link 1”, “Link 2”,
“Link 3” or “Link 4”.
3.
The desired URL commands must be created on the
device supplier website and copied.
4.
From the main
menu in the
COMELIT app,
select:
MANAGE DEVICES
DOOR ENTRY MONITORS
Program buttons
5.
Select the key to
configure.
Only keys associated with
the “Link” function can be
configured.
6
7
6.
Enter the name to be
associated with the
command (this will
be shown on the key
associated with the Link)
7.
Paste the URL link created
beforehand.
8.
Confirm the changes.
< BACK