580A
www.comcast-sa.com
Trouble Shooting.
Problem
Causes
Solution
Turn on button doesn't
work and machine cannot
be opened
1.The battery is over-used
or damaged
2.Failures of motor or
circuit board
3.The battery is not insert
or inserted tightly
Change battery or install
battery again after it is
fully charged. If still
failed, send the machine
to
professional maintenance
personal for repair
Motor works, but no wire
comes out
1. Without wire coil or
install non-designated wire
coil
2. The end of the wire is
not straightened
1. Insert designated wire
coil
2. Straighten the end of
the wire
The machine doesn't work
1. Low battery
2. The gearing is jammed
3. Failures of motor or
circuit board
1. Fully charged the
battery
2. Open the gearing and
take out the stuff
The wire fail to be cut off
Wear of the wire cut blade
or wire guiding block
Change the wire cut blade
or wire guiding block
Wire shifting: the wire is
not in the right place of the
jaw, which leads to tying
failure
The jaw is blocked, which
will cause intervention of
wire track. As a result, the
wire does not come out in
the right place.
Adjust the tying angle and
clean the obstacles in the
wire track, so as to
eliminate all interference
Charger indicator light off
The charger failures
Replace it with a new
charger
Buzzer Alarm
1. the machine does not
be
used after turn on the
power switch over one
minuter
2. Run out of the battery.
1.Switch off and restart the
machine
2.Fully charged the battery
or change the battery
