4
www.combisteel.com
1. DESCRIPTION
The hand dryer is a surface-mounted hand dryer powered by a brushless or brush motor, and delivers 1650 watts
of drying power. The dryer incorporates a replaceable HEPA filter and a reused air intake pre-filter. An infrared
sensor is used to automatically activate the dryer. The dryer is intended for use in commercial, industrial, office
and public facility environment.
2. ADANCE FEATURES
THIN design with rapid drying, cost effective and most hygienic.
25Seconds continuous timer protection.
Anti-splash structure design.
Using highly efficient motor to create strong air flow to scrape the water off the hands.
No disposal, storage and labor cost compared with paper towel, only clean once a day.
Clean air by UV sterilization to keep air bacteria free.
99% of all bacteria filtered by HEPA filter with easy changeable system.
Up to 90% saving compared to paper towel costs.
ECO-friendly product by power saving clean technology and less amount of carbon dioxide.
3. SPECIFICATIONS
Voltage:
220V-240V 50/60Hz
Power:
1850W(Heater on)/750W(Heater off)
Air Temperature: 40
℃
(Room Temp.= 25
℃
)
Air Velocity:
100M/S
Air Flow:
150M3/H
Drying Time:
7-9S
Protection Level: IPXI
Electric Isolation: CLASS II
Motor:
Brush Motor
Noise(at 1M):
70dB
Cabinet Material: ABS Plastic
Net Weight:
7.5KGS
Gross Weight:
9.3KGS
4. SAFETY INFORMATION
DANGER Failure to disconnect the power source before installation or servicing can result in serious injury or
death from electric shock. Always disconnect the power source before servicing or installing the hand dryer.
WARNING Risk of fire, electric shock, personal injury or property damage are possible if local codes, or safety
recommendations are not followed.
Use only for drying hands and do not use hand dryer for any purpose other than drying hands.
Carefully follow all instructions for installation on the enclosed installation template/instructions.
Installation should only be performed by qualified persons in compliance with all applicable national and
local codes and standards.
When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
Always connect to a branch circuit with circuit breaker or fuse protection with an electrical rating greater
than the model hand dryer’s rated amperage.
Use only the electrical power(voltage and frequency) specified for the model hand dryer being installed.
Each hand dryer must have a dedicated circuit.
For indoor use only. Do not use outdoors. Do not expose to rain, sun or extreme temperatures. Do not use
near source of water or extreme heat.
To limit a voltage drop, and insure efficient operation, use of right size wire is required.
