Section 12 - Installation with
Navette 22 / Shuttle 22 Base (continued)
49
Move the Recline Adjustment Foot back up
into the use position.
If the Lower Anchor Strap is too short,
rotate the Lower Anchor Strap adjuster
upwards to loosen the Lower Anchor
Strap
(fig. b)
.
Pass the Lower Anchor Strap over the
front of the base threading the belt under
the vehicle belt routing tabs, and through
the built in locking clip
(fig. c)
.
Check that belt is not twisted.
Place base rear-facing in the
vehicle seat location selected
with the Recline Adjustment
Foot against vehicle seat back
and centered between the vehicle
lower anchors
(fig. d)
.
Check Base installation angle.
See section 12f “Adjusting Base
For Proper Car Seat Recline”.
5
6
(fig. c)
(fig. d)
LATCH Belt
7
8
9
Vehicle Belt
Routing Tabs
Locking
Clip
Lower
Anchor
Belt
Lower
Anchor
Belt
Adjuster
Pull
(fig. b)
Section 12 - Installation with
Navette 22 / Shuttle 22 Base (continued)
50
Connect lower anchor connectors to
vehicle lower anchors:
- With hook-on connector opening
facing down , position the opening
of the connector over the vehicle lower
anchorage. Push down and then pull
out on the connector to lock it onto the
vehicle anchorage
(fig. e)
. You should
hear a click.
- Pull on connector to be sure it is locked
onto the anchorage.
- Repeat for connector on opposite side.
1
2
3
10
(fig. e)
1
3
2
All manuals and user guides at all-guides.com
all-guides.com