ComAp InteliMains NT IM-NT, Справочное руководство

Страница: 167 / 437

InteliMains
NT
, SW version 3.2.0
InteliMains-NT-MCB-MGCB-3.2.0-Reference Guide.pdf,
©ComAp – April 2015
167
Related FW standard v3.1.0
Force value
possible YES
Description The setpoint is used to enable/disable the island operation, i.e. supplying the
load while the mains is disconnected.

Island mode is recognized if the mains breaker is open , e.g. the
feedback input MCB feedback is not active.

Parallel mode is recognized if the mains breaker is closed , e.g. the
feedback input MCB feedback is active.
If the island mode is recognized and island operation is disabled the
controller will open the master generator breaker, and system will be stopped
(i.e. gen-sets will cooldown and stop, GCBs will open). While this situation
persists the controller behavior is following:

The gen-sets may be started in MAN mode but they will not start in
AUT mode due to MGCB not closing.

The MGCB can't be closed.

The message StartBlck is present in the alarm list (see the alarm
output OfL StartBlck ).
N
OTE
:
See table with examples in the description of the setpoint MFStart enable .
11.2.1.24 Setpoint: ParallelEnable
Group Process Control
Range [units] NO, YES [-]
Related FW standard v3.1.0
Force value
possible YES
Description The setpoint is used to enable/disable the parallel operation, i.e. supplying
the load in parallel with the mains.

Island mode is recognized if the mains breaker is open , e.g. the
feedback input MCB feedback is not active.

Parallel mode is recognized if the mains breaker is closed , e.g. the
feedback input MCB feedback is active.
If the parallel mode is recognized and parallel operation is disabled the
controller will open the master generator breaker, and the system will be
stopped (gen-sets will cooldown and stop, their GCBs will open). While this
situation persists the controller behavior is following: