18
WORK
10. Position the selector on forwards (9)
11. Select the advance speed by turning the knob
12. Turn the lever (10) clockwise to turn on the tap. The water indicator light only
switches on during the advance phase
9
10
13. Position the brush lever downwards (1) to lower the base. During the descent, the
indicator lights of the jack and the brush motor will switch on. The brush base will
be in its working position when the yellow indicator light (2) switches off.
14. Press the accelerator pedal. The machine will begin to move, the squeegee will
lower and the suction motor will switch on.
During the first metres of operation, check the brush pressure is suitable (see
“BRUSH PRESSURE” below), the quantity of detergent solution is sufficient, and
that the squeegee dries perfectly.
The machine will now start to work efficiently until the detergent solution runs out.
If problems occur while working, immediately disconnect the emergency lever
(1) situated on the left side of the operator and apply the emergency brake (2).
These commands block all moving machine parts. To start the machine again, once
the problem has been solved, turn off the key (3), reconnect the connector (1), switch
on the key (3) and lower the parking brake lever (2).
The machine will not start if the operator is not properly seated.
When the solution tank is empty, the indicator light on the instrument panel switches
on.
When the recovery tank is full, the suction motor stops. To start it up again, even if the
tank has been emptied, it is necessary to turn the main switch key off and on again.
1
2