COMAC ULTRA 120 B-G, Руководство по эксплуатации и обслуживанию

Страница: 58 / 72

58
MAINTENANCE
CLEANING THE WATER SYSTEM (VERSION WITHOUT CDS)
If the machine is to be left unused for a long time, perform the
following tasks:
1. Select the i-drive program “transport” by rotating the knob (1) to
position “A” as shown in ( Fig.1 ).
2. Take the machine to the maintenance area.
ATTENTION:
the place designated for this operation must
comply with current environmental protection regulations.
3. Check the water tap is fully open - the lever (2) must be turned
completely clockwise ( Fig.2 ).
4. Select the i-drive program “scrubbing with drying” by rotating the
knob (1) to position “C” as shown in ( Fig.3 ).
ATTENTION : rotating the i-drive selector to the scrubbing with
drying program, the brush head and squeegee unit will move
to their working positions (in contact with the floor).
5. Press the drive pedal (3) to activate the brush head and the
dosing system ( Fig.4 ).
ATTENTION : as soon as you press the drive pedal, the brush
head and squeegee unit will move down until they are in
contact with the floor, and will start working. At the same time,
the solenoid valve and dosing system will start dispensing the
detergent solution.
6. Wait a few minutes, normally 2 – 4 minutes, to allow the dosing
system to be washed.
ATTENTION: the machine will dispense solution during this
operation.
7. When you have finished washing the machine water system,
drain the solution tank completely (read “ DRAINING THE
SOLUTION TANK ”).
If the machine is to be left unused for a long time, perform the
following tasks:
1. Select the i-drive program “transport” by rotating the knob (1) to
position “A” as shown in ( Fig.1 ).
2. Take the machine to the maintenance area.
ATTENTION: the place designated for this operation must
comply with current environmental protection regulations.
3. Bring the main switch (2) on the control panel to "0", turning the
key (3) a quarter turn to the left (
Fig.2
). Remove the key from
the main switch.
4. Get off the machine.
ATTENTION: do not position your foot above the brush head
while the machine is coming down the ramp.
CLEANING THE WATER SYSTEM (VERSIONS WITH CDS)
ATTENTION: protective gloves should always be worn when
handling detergents or acidic or alkaline solutions, to avoid
serious injury to the hands.
5. Remove the cap (4) of the detergent canister ( Fig.3 ).
6. Fill the detergent canister with water.
ATTENTION: fill with clean water, at a temperature no greater
than 50°C and no less than 10°C.
7. Replace the cap on the canister.
8. Sit on the driver’s seat.
9. Insert the key (3) in the main switch (2) on the control panel. Bring
the main switch (2) to "I", turning the key a quarter turn to the
right ( Fig.4 ).
3
3
4
4
1
1
2
2
1
1 1
1 1
1
1
1
1
1
2
3 3
2 2
1
1
1
4
3