ADJUSTMENTS
AND
INSPECTIONS
SIMPLA 50 BS
Doc. 10001246
Emitted 07/2006
Rev. 00
Pag.
3 di 4
Adjustment brushes base
1.
Adjustment the screw, so that the weight of the tank doesn’t rest
completely on the frame; fix the adjuster nut.
2.
Adjust the lifting tie rods: adjust the fork of the
vertical tie rod
so that, with the lift base, it doesn’t interfere with tank.
3.
Adjust the fork of the
horizontal tie rod
avoiding that the base
lifting arms interfere with the frame and that the brush cover
doesn’t contact the solution tank. Make sure that, without brush,
the brush plate is almost to touch the floor (0 - 1 mm).
4.
Adjustment Point III: Adjustment
screws M6
,
so that the lower
brush bases touch on the back and it’s higher in front of 2-3 mm.
Screw that is on support of Point III must come out about
20 mm.
5.
Fix adjuster nut.
6.
Adjustment horizontal inclination: place machine on a levele floor;
mount brushes and lower base on the floor; loose the
screw
on
the left lifting arm so that the base touches the floor, support of
the base will position itself correctly; fix nut and bolt.
7.
This function assure a correct ranging on the floor of the brush
base for a uniform cleaning on the ……….floor?
8.
Check the
spring of unloading
of pressure screwing the
screw
M6
on the tie rod making it goes out 2-3 mm., so that pressure of
the base is 15-16 Kg.
9.
Assemble the joint chain of transmission so that a distance of 2
mm. between two hubs is obtained and tyre toothed star is
between two hubs, works correctly, avoiding vibration and shift.
10.
Fix dowels and adjuster nuts.
11.
Check tension of transmission belt working of screw M8, so that
the thread goes out from support of about 28-29 mm.