27
DAILY MAINTENANCE
4. DISASSEMBLING AND CLEANING THE SQUEEGEE
Check the squeegee is always clean, for better drying results.
To clean it you must:
1.
remove the tube (1) from the squeegee
2.
remove the squeegee, pushing the plate (2) to the left in order to release the squeegee small column
from its seat
3.
pull the squeegee to the right until the left-hand small column is released from its seat
4.
carefully clean the inside of the squeegee and its suction nozzle
5.
carefully clean the squeegee rubbers
6.
reassemble all the elements
ATTENTION: Before performing any maintenance, remove the keys from the
panel and disconnect the battery connector of the machine.
5. DISASSEMBLING THE BRUSH
1.
Turn the key anticlockwise to “OFF”
2.
Raise the brush head, using the lever
3.
With the brush head up, rotate the brush until it comes out of the brush-holder plate seat, as shown in
the figure. The figure shows the rotation direction to uncouple the right-hand brush; for the left-hand
one, rotate in the opposite direction
4.
Always check the bristles for signs of wear. You are advised to replace the brushes when the bristles
are less than 15mm long
ATTENTION: this operation must be carried out using gloves to protect against
contact with dangerous solutions
ATTENTION: Before performing any maintenance, remove the keys from the
panel and disconnect the battery connector of the machine.
6DISASSEMBLING THE BRUSH (BRUSH HEAD WITH CYLINDRICAL BRUSHES)
To remove the brushes:
1.
Turn the key anticlockwise to “0” (1)
2.
stop the machine moving by applying the brake lever (2)
3.
insert the blocking pin (3) in the holes of the brake handle to prevent the lever slipping
ATTENTION: do not leave the machine on sloping or wet floors, and check the
parking brake is correctly applied
1
2
2
1
3