24
AT THE END OF THE WORK
1 . AT THE END OF WORK
At the end of the work, and before carrying out any type of maintenance:
1.
raise the brush head by means of the pedal (2) or the key (6) (automatic version)
2.
Raise the squeegee by means of the lever (3) or the key (4) (automatic version). When the squeegee
is up, the suction motor switches off automatically
3.
bring the machine to the place provided for draining the water
4.
Turn the key switch (5) anticlockwise to ‘0’ to switch off the machine, then remove the key from the
block before starting any maintenance or cleaning operation
5.
pull the brake lever and block it with the pin (7)
6.
Remove the drainage hose (8) from its compartment, unscrew the drainage cap (9) and empty the
recovery tank
7.
the squeegee must be raised when the machine is not operating in order to avoid deforming the
rubber blades
8.
disassemble the brushes and clean them with a jet of water (to disassemble the brushes, see
“DISASSEMBLING THE BRUSHES” below)
9.
Remove the debris hopper and clean it carefully with a water jet (MEDIA 60BS)
ATTENTION: These operations must be carried out using gloves to protect
against contact with dangerous solutions
10.
At the end of the work, park the machine in a closed place. Raise the squeegee and brush head using
the reference lever or the specific key (AU version), then turn the key switch anticlockwise and take
out the command key. Apply the parking brake and block the handle with the pin (1), inserting it in the
lever holes. After inserting the pin (1), ensure the flat surface of the pin is resting on the surface of the
handlebars.
Do not leave the squeegee and brush head resting on the floor for a long time.
ATTENTION: do not leave the machine unattended without first removing the
start-up switch key and applying the parking brake. In addition, do not park the
machine in open places or on sloping floors
2
3
4
5
6
7
8
9
1