34
WORK
If the dirt level requires it, lower the right side brush, (1SL versions) using the lever (7) on the control
panel. If you want to lower the optional left brush (2SL versions), use the lever (8)
ATTENTION:
Use the side brush or brushes (according to machine version) only
on edges, as it is not assisted by the vacuum action.
WARNING:
Both the central brush and the side brush will begin rotating as soon as
they are in their work position.
In order to achieve a correct vacuum action, clean the filter every 10 minutes and always before any
discharge of the debris hopper. To do this, proceed as follows:
1.
Stop the machine and engage the parking brake
2.
Raise the central brush, using the lever (1) on the control panel
3.
Raise the side brush or the side brushes if lowered, using the lever (2) for the right brush and the lever
(3) for the left brush on the control panel
4.
Switch off the vacuum, turn the lever (4) to the right
5.
Activate the filter shaker on the filter by pressing the switch (5) on the control panel
Periodically check the filling of the tray and if necessary proceed to empty it. Bear in mind that the weight
of the dirt collected is proportional to the specific weight of the material brushed up. In the case of heavy
material such as sand, soil, gravel, etc. the tray should ideally not be filled more than 70%, otherwise it
may be difficult to empty
ATTENTION!
Do not keep the switch (5) pressed longer than ten seconds, repeat
this operation two or three times.
If during the work the amperage draw (only for the battery versions) reaches a critical level, the machine
should be stopped. The machine is fitted with display for diagnosing system anomalies and checking the
electrical motor. Once a critical threshold has been reached, a horn will activate in this case, it is
necessary to stop, park the machine in a suitable place and call for assistance.
If during the work the red warning light shown here on the side on the instrument panel comes on, it
indicates that the level of oil in the braking system is "poor", you need to stop the work you are doing and
take the machine to a suitable place for its maintenance and call for assistance.
8
7
1
3
2
4
5