12
WORK
MACHINE STARTING SWITCH
1. Turn the key in position
1
(clockwise direction).
2. Check that the batteries electric charge is enough to do the foreseen
work.
4
= maximum charge,
3
= charge 3/4,
2
= charge 2/4,
1
= charge 1/4,
0
= discharged batteries (blinking)
To avoid permanent damages to batteries, it’s essential to avoid the
complete batteries discharge. When the meter reads “0” blinking on the
display, the machine automatically switches off, having only the
capacity to reach the charge point.
STARTING SIDE BRUSH
1. To operate the side brush, lower the external lever (1) until it arrives to
the bottom plate base. The lever hooks automatically.
2. To stop the side brush rotation is enough to push the lever through the
external. The lever lifts automatically and the brush will stop.
ATTENTION
: Use the side brush only on the floor perimetric edge,
because the collection is without the suction.
STARTING MACHINE
1. Push the accelerator pedal to move and regulate the machine speed
according to the dust and waste quantity that are on the floor.
2. We advise to not use the brushes if a transfer gear is operated.
ATTENTION:
the machine has a microswitch of presence operator on
board that is under the seat. This microswitch doesn’t allow to go on
with the machine if the operator is not sit correctly.
SUCTION OPENING
The machine works in normal conditions with the closed knob because the
dirty is not assembled by the brush and sucked up in the hopper.
Operating on the knob you operate on the dirty suction. Pulling lightly, the
dirty air flow in the hopper will stop. Pulling again few seconds the knob the
filter shaker motor, that frees the dirty catched by the filter, is activated. To
obtain efficient suction, clean the filter every about 10 minutes and always
before every discharge of the hopper.
ATTENTION:
Avoid the prolonged operating of the filter shaker motor.
Close the suction when you work on wet or humid floor to avoid to ruin the
filter.
1