COMAC 109160, Руководство по эксплуатации и обслуживанию

Страница: 29 / 44

AT THE END OF THE WORK
At the end of the work, and before carrying out any type of maintenance, perform the following operations:
1. For the manual machine versions, raise the squeegee body and rotate the lever (1) in the rear part of the steering column clockwise ( Fig.1 ).
2. For the manual machine versions, raise the brush head body and rotate the lever (2) in the rear part of the steering column anti-clockwise
( Fig.2 ).
3. For the automatic machine versions, use the knob (3) ( Fig.3 ) to select the "transfer" working program (A) ( Fig.4 ).
4. Press the drive pedal (4) ( Fig.5 ) to begin moving the machine.
5. Take the machine to the maintenance area.
WARNING: the place designated for this operation must comply with current regulations concerning safety at work and current environmental
protection regulations.
6. Turn off the machine and make a quarter turn anti-clockwise with the key (5) ( Fig.6 ). Remove the key from the instrument panel.
7. Carry out all the procedures listed in the paragraph "ROUTINE MAINTENANCE" on page 30, as indicated in the “AT THE END OF THE
WORK” column.
8. Sit on the driver’s seat.
9. Insert the key (5) into the main switch on the control panel.
10. Turn on the machine and make a quarter turn clockwise with the key (5) ( Fig.7 ).
11. Press the drive pedal (4) ( Fig.5 ) to begin moving the machine.
12. Take the machine to the designated machine storage place.
ATTENTION: Park the machine in an enclosed place, on a flat surface; near the machine there must be no objects that could either
damage it, or be damaged through contact with it.
13. Secure the machine, see paragraph "MACHINE SAFETY" on page 15.
29
6
7
5
5
5 1 2
1
2
3
3
4
D
C
B
A
4