COM-power corporation CLCI-400, Инструкция по эксплуатации

Страница: 10 / 30

Page 10 of 30
INSTRUCTION MANUAL
SEC TI ON 3
- PRODUCT I NFORMATION
Rev081219
Fixture Opening
The CLCI-400 is installed within this opening so that the center conductor rod of the fixture
passes through the approximate center of the probe aperture.
Center Conductor Rod
This is the fixture’s center conductor.
Calibration Fixture Coaxial Ports
These are female N-type coaxial connectors providing input/output connections to the
fixture.
Thumb Screws for Removable Top Plate
These (6) screws secure the fixture’s top plate to the fixture assembly.
Removable Top Plate of Fixture
In order to install/remove the clamp into/from the calibration fixture, the top plate must be
removed by removing the six (6) thumb screws. The top cover and thumb screws must be
replaced prior to the performance of tests.
Teflon Spacers
These spacers help in centering the clamp within the fixture; and thereby aligning the center
conductor through the center of the probe window.