4
HUMIDITY Button:
Press the HUMIDITY button repeatedly to adjust the set-point of humidity level
between 30%-80% (in 5% increments) during normal DEHUMIDIFY (DH) mode. The digital number
on the display will flash when changes are being made.
NOTE:
The HUMIDITY button will be disabled in the DRY-CLOTHES (DRY) mode.
SPEED Button:
Press the SPEED button to set the fan speed to FAST or SLOW in the normal
DEHUMIDIFY (DH) mode.
NOTE:
The SPEED button will be disabled in the DRY-CLOTHES (DRY) mode.
TIMER Button:
Use this TIMER button to set
an AOTU-ON or AUTO-OFF timer, between 1-24 hrs.
When timer function is enabled, the system will countdown the time remaining and you can check
the time remaining by pressing the TIMER button once.
LIGHTING Button:
Press the LIGHTING button to
send the display to sleep status where
the digital
display and the backlight of the buttons other than the POWER button and the LIGHTING button will
go off and these buttons will be disabled, while the dehumidifier maintains running status. The
indicator light above the LIGHTING button will light up in this case. Press the LIGHTING button again
to restore the backlight and functions of these buttons.
NOTE:
Press and hold the SPEED button for 3-5 seconds, the LCD will show the room temperature
readout in Fahrenheit. 5 seconds later, the LCD will turn back to display the room humidity readout.
2) Understand the LCD Display
The BIG FONT Digital Number
is humidity reading. If no operations on the control panel, the
number is the humidity percentage readout of the inlet air the dehumidifier detects which is similar
to the room humidity level. When you are pressing the HUMIDITY button to set the target humidity
percentage value, the digital number will turn to display the setting value and flash.
FULL:
The
“
Full
”
icon will light up when the bucket is full of water, as a reminder to empty the water
bucket. Empty the bucket and re-install the bucket properly to resume regular functioning.
FAST:
The
“
FAST
”
icon will light up when the FAN speed was set to high.
SLOW:
The
“
SLOW
”
icon will light up when the FAN speed was set to low.
DRY:
The
“
DRY
”
icon will light up when the DRY-CLOTHES mode has been selected.