Colorlight X12, Инструкция по эксплуатации

Страница: 9 / 26

7 / 23
4.2.1 Mapping Settings
Select the target Ethernet port on the left side, and set the connection lines of the
corresponding cabinets within the port control area in the simulated cabinet area.
In the simulated cabinet area, select the corresponding cabinet of the first receiver card
based on the actual connection of the Ethernet port (look from the front), and left-click the
cabinet one by one according to actual connection line, until the last one this Ethernet port
controls.
For the cabinets with different specifications (different in dimensions), you can select
them and adjust the mapping separately after setting.
4.2.2 Saving Mapping
After successively setting the cabinets each port controls and their mapping, click Send
at the bottom of the window to test whether the current mapping is correct. If the image on
the LED screen is displayed normally, click Save to Devices to save the mapping to the
current sender and receiver cards.