Page
14
of
47
NEPTUNE HQ
9. Head Installation
Use this section, if Print Head is not installed in the printer.
The installation of Print Heads is to be done only by a service engineer. If the Print Head is not installed
correctly, it can affect the printing quality.
Note: Don’t apply
much pressure on
Print Head
while handling it.
Follow these steps to install the Print Head:
Step 1
: Remove the
Ink Inlet caps
gently to avoid damage to the Print Head, as shown below:
Fig 14: Removing the Ink Inlet Caps
Step 2:
Fix the
Air Releasing
and
Ink Sub Tank pipes
on the
Ink Inlet Tube
, as shown below:
Fig 15: Fixing Air and Ink Sub Tank Pipes
Step 3:
Remove the
Nozzle Cap
from the Print Head (Refer to Fig 15).
Note:
Don’t put the Print Head (nozzle facing) on the rough or dusty surface.
Step 4:
Mount the
Print Head
in the slot on the
Head Plate
.
Ink Sub Tank Pipe
Air Releasing Pipe
Nozzle Cap
