Page
55
of
62
Metro (Konica Head)
a)
Wait for the completion of the current printing process. If the print command repeats, then
immediately stop giving the next print command for printing.
b)
Takeout the fabric, lower down the tub, and run glue cycle in reverse direction with the 70%
speed.
c)
Rotate the Belt in the reverse or opposite direction until it comes in the Center. Once the belt has
positioned centrally, stop the glue cycle. Now, the shifting control adjustment has to be done as
mentioned further in next section.
Belt Shifting Control
Follow the below given instructions to control the conveyor belt shifting:
•
Belt shifting can be controlled ‘on the fly’ as well as when print is stopped.
•
To control belt shifting, move the Shifting Control knob in the required direction.
Glue Coating Layer
•
It is strictly recommended that the Company suggested glue has to be used, otherwise it may
cause damage to the sponge rollers, conveyor belt, brush motor assembly, and belt motor
coupling.
•
Glue coating has to be checked from time to time for its adhesive strength. Whenever required,
fresh coating is to be done. Also wiping with wet cloth can clean the previous coating layer
sometimes.
Precautions:
•
If the glue layers are peeling off partly, it may harm the print head and also results in printing
wastage.
•
If Glue adhesion goes less, it can damage the print head as the fabric gets entangled with the Print
Head during printing.
Environmental Maintenance
•
Room temperature should be maintained in 23-28-degree Celsius range with humidity 60-
80%RH
•
Closed dirt-free room exclusive for Printer
•
Proper cool with white lightings
Daily Maintenance
•
Renewal of water is done every 4 hours in the Water tank.
•
Add 2 spoons of caustic soda in every water recycle.
•
Keep the Capping Plate surface clean, particularly before capping.
•
Wiper blades should be cleaned using water rinse.
•
Run the Wash Cycle after finishing each fabric roll and also remove the fabric thread, if any.
•
Check the Waste ink bottle and empty it, if required.
•
Clean the purging tray daily.
•
Check ink level in Main ink tank and refill it, if empty.
•
Maintain the recommended air pressure.
•
Belt shifting should be regularly monitored and adjusted, if required.
