Page 1
Step 1
Remove the Printer and Accessories from packaging.
Place the Printer on a stable surface.
Step 2
Hydrate the Printhead.
Before you begin assembling the Printer, it is a good idea to hydrate the Printhead Cartridge for about 20 minutes.
CAUTION
Use electrostatic discharge (ESD) protection when handling.
Hold the Printhead Cartridge by the handles ONLY.
DO NOT touch the ink couplings, nozzle surface or electrical contacts.
DO NOT unpack the Printhead Cartridge until the Printer is ready for installation. Once unwrapped,
delay in installing the Printhead can compromise print quality due to dehydration.
DO NOT place an unwrapped Printhead on any surface before installing. Protect the Printhead from
dust, fibers, dirt and other contaminants at all times.
1. Carefully remove the Printhead Cartridge from the foil
packaging
.
[A] Tear at notch or cut end with scissors.
[B] Remove the protective plastic cover.
Hold the
Printhead by the handle and unclip the cover from the
Printhead.
[C] Remove protective strip from the Printhead Electrical
Contacts
.
DO NOT allow removed strip to touch the
electrical contacts.
[D] Remove protective strip from the Printhead Nozzles.
Hold the Printhead by the handle with one hand. Pull the
strip tab with the other hand and slowly peel the strip from
the Printhead
. DO NOT pull the strip at any angle less
than 45° with the Printhead surface. DO NOT allow
removed strip to touch the Printhead Nozzles.
2.
Pour just enough distilled water into the orange plastic cover you removed in Step 1B to moisten the bottom
strip inside. Carefully reinstall the Printhead back into the plastic cover. Set the Printhead aside for installation
later. This rehydrates the Printhead and allows easier priming once it is installed in the Printer.
Colordyne 1600-S
Quick Start Guide