R
OTA
400
Collomix GmbH
D-85080 Gaimersheim
10
Version G 1.5-18
5.
Set-up and using the Shaker for the first time
5.1
Content
The biaxial mixer is delivered with the following:
These Operating Instructions
A rubber band to secure the handles
A power supply cord
5.2
Transport
The mixer is equipped with two transport rollers on the bottom of the housing. These transport
rollers can be made to protrude out of the mixing compartment by turning a screw (1) on each side
of the machine.
•
Use a cordless drills or some other suitable tool size SW 17 to turn out the transport rollers on
both sides of the machine.
•
The door must be opened for the machine to be handled safely during transport. Secure the
opened door with the hand against swinging
•
Carefully tilt the mixer and move it.
When you are finished moving the machine, turn the transport rollers back.
5.3
Set-up the equipment
When setting up the machine, the applicable electrical requirements and the additional information
in this Operating Instructions must be followed.
The machine is delivered on a wooden pallet packaged in recyclable cardboard. Check the packaging
immediately upon receipt and the equipment when unwrapping it for any visual external defects.
Keep all parts of the original packaging for a possible necessary return.
Remove the machine from the pallet with a suitable lifting tool and place it on solid and level
ground.
Adjust any unevenness in the floor with the height-adjustable legs (11).
Do not operate the machine on the shipping pallet or on any other suitable sub-surfaces.
5.4
Trial run
A trial run with an empty mixing container must be conducted when first starting the machine or
after maintenance and repair work in order to check the proper function of the machine.
WARNING
Risk of injury due to protruding parts
Parts may protrude from the equipment.
•
Always work diligently on the equipment and in close proximity of the equipment.
•
If the machine is not used and turn it off on the main switch.
Machine legs
