TECHNICAL GUIDE
95.5% SINGLE STAGE
GAS-FIRED RESIDENTIAL
MULTI-POSITION GAS FURNACES
MODELS: TG9S
NATURAL GAS
40 - 130 MBH INPUT
Due to continuous product improvement,
specifications are subject to change without notice.
Visit us on the web at www.york.com for the most
up-to-date technical information.
Additional efficiency rating information can
be found at www.gamanet.org.
EFFICIENCY
RATING
CERTIFIED
ISO 9001
Certified Quality
Management System
400992-CTG-C-0209
FOR DISTRIBUTION USE ONLY - NOT TO BE USED AT POINT OF RETAIL SALE
WARRANTY
Lifetime limited warranty on the heat exchanger.
10-year heat exchanger warranty on commercial applications.
5-year limited parts warranty.
DESCRIPTION
These compact units employ induced combustion, reliable hot
surface ignition and high heat transferaluminized tubular heat
exchangers. The units are factory shipped for installation in
upflow or horizontal applications and may be converted for
downflow applications.
These furnaces are designed for residential installation in a
basement, closet, alcove, attic, recreation room or garage and
are also ideal for commercial applications. All units are factory
assembled, wired and tested to assure safe dependable and
economical installation and operation.
These units are Category IV listed and may be vented either
through side wall or roof applications using approved plastic
combustion air and venr piping.
FEATURES
•
Easily applied in upflow, horizontal left or right, or downflow
installation with minimal conversion necessary.
•
Compact, easy to install, ideal height 33" tall cabinet.
•
Blower-off delay for cooling SEER improvement.
•
Easy access to controls to connect power/control wiring.
•
Built-in, high level self diagnostics with fault code displays
standard on integrated control module for reliable
operation.
•
Low unit amp requirement for easy replacement
application.
•
Single wire twinning or staging feature available.
•
All models are convertable to use propane (LP) gas.
•
Electronic Hot Surface Ignition saves fuel cost with
increased dependability and reliability.
•
100% shut off main gas valve for extra safety.
•
4 speed, direct drive PSC motor.
•
24V, 40 VA control transformer and blower relay supplied
for add-on cooling.
•
Hi-tech tubular aluminized steel primary heat exchanger.
•
Secondary heat exchanger made of corrosion resistant
stainless steel materials.
•
Timed on, adjustable off blower capability for maximum
comfort.
•
Blower door safety switch.
•
Solid removable bottom panel allows easy conversion.
•
Airflow leakage less than 1% of nominal airflow at
ductblaster conditions.
•
No knockouts to deal with, making installation easier.
•
Movable duct connector flanges for application flexibility.
•
Quiet inducer operation.
•
Inducer rotates for easy conversion of venting options.
•
Fully supported blower assembly for easy access and
removal of blower.
•
External air filters used for maximum flexibility in meeting
customers IAQ needs.
•
Protection included from air intake, exhaust vent, or
condensate blockage.
•
Venting applications - may be installed as either 2-pipe
(sealed combustion) or single-pipe vent (using indoor
combustion air).
•
No special vent termination required.
•
1/4 turn knobs provided for easy door removal.
•
Internal condensate trap design (patent pending) provides
condensate management options, easy visual operation,
and is self-priming to prevent nuisance problems.
