INSTRUCTION FOR USE
CAUTION: CAREFULLY READ THE INSTRUCTION
MANUAL BEFORE USE. Keep these instructions in a
safe place so that you can refer to them if needed.
IMPORTANT SAFETY INSTRUCTIONS
WARNING:
When using electric appliances, basic
precautions should always be followed, including the
following:
1. Do not install the batteries backwards, follow the + and
- symbols as shown in the instructions. Do not charge
or put in a
fi
re. Do not mix battery types. Do not mix old
and new batteries. The batteries may explode or leak
causing injury.
2. Do not leave discharged batteries in the product for an
extended period of time as this could permanently
damage the product.
3. Replace all batteries at the same time.
TO INSTALL OR REPLACE BATTERIES
Your lantern operates on 8 “D/LR20” batteries. For longest
life, use alkaline batteries.
CAUTION:
DO NOT MIX OLD AND NEW BATTERIES.
DO NOT MIX ALKALINE, STANDARD (CARBON-ZINC),
OR RECHARGEABLE BATTERIES. RESULT COULD
LEAD TO OVER-HEATED CIRCUIT AND DAMAGE TO
LANTERN.
1. With lantern off, turn upside down and unscrew base
by rotating counter clockwise.
2. Install 8 batteries in the correct orientation as shown on
the battery housing. Always be careful that all 8
batteries are installed correctly (Fig. 1.)
3. Replace base by screwing clockwise until hand tight.
Check that base is securely installed in closed position.
TO OPERATE IN LANTERN MODE
1. To turn lantern “ON”, press On/Off Switch on top of
lantern (Fig. 2). All four Removable Area Lights will turn
on for 360º of area lighting.
2. To turn lantern off, press On/Off Switch once again
(Fig. 2).
TO OPERATE REMOVABLE AREA LIGHT(S)
One or more Removable Area Lights can be used as
independent light sources when removed from “Docking
Station”, and then be returned to the lantern “Docking
Station” for full 360º area lighting and/or recharging.
1. Push in Release Button located on front of the
Removable Area Light while pulling forward on handle
to release from locked/charging position (Fig. 3).
2. Lift out Removable Area Light (Fig. 4).
NOTE:
If the Lantern Mode is “ON”, the remaining
Removable Area Lights will remain lit.
3. Push On/Off Switch on back of Removable Area Light
to turn “ON” or “OFF” (Fig. 5).
NOTE:
When reattached to the lantern “Docking
Station”, the Removable Area Lights will be recharged
by the 8 “D” cell batteries located in the lantern base.
4
0
1
0
0
2
3
3
5
5
8 D Quad Lantern
www.coleman.eu
