Coleman Powersports UT250-2, Руководство пользователя

Страница: 41 / 61

Periodic Service
10-8
UTV is new. Tighten to the specified torque
below.
①
Torque wheel bolts to 55 to 66 lb.ft (75 to 90 N.m)
■
Cleaning air cleaner primary element
1. Remove the air cleaner cover and primary
element.
2. Clean the primary elements.
1
）
When dry dust adheres to the element blow
compressed air from the inside while turning
the element. Pressure of compressed air
must be under 30psi (205kpa).
2
）
When carbon or oil adheres to the element
soak the element in detergent for 15 minutes
then wash it several times in water rinse with
clean water and dry it naturally after element
is fully dried inspect inside of the element
with a light and check if it is damaged or not.
3
）
Replace the primary element
Once yearly or after every sixth cleaning,
whichever comes first.
①
First air cleaner
②
Air cleaner case
③ Air cleaner element ④ Cover
IMPORTANT

The air cleaner uses a dry element never
apply oil.

Do not run the engine with filter element
removed.

Be sure to refit the cover with the arrow (on
the rear of cover ) upright. if the cover is
improperly fitted the evacuator valve will not
function and dust will adhere to the element.
◆
Evacuator Valve
Open the air cleaner cover once a week under
ordinary conditions
–or daily when used in a
dusty place-to get rid of large particles of dust
and dirt.
Check fuel line and fuel filter.
WARNING
To avoid personal injury:

Be sure to stop the engine and remove