Colasit CMVpro 125-400 ATEX, Руководство по эксплуатации, Страница: 69 / 88

Repair | 12
Operating instructions CMVpro 125-400 ATEX | Version 1-en 69 / 88
12.3 Spare parts and wear parts
DANGER Risk of injury due to impeller explosion
Serious injuries due to debris being launched out.
▪ Prohibited spare parts.
u
Only use an original impeller from the manufacturer as a spare part.
DANGER Risk of explosion due to prohibited spare parts
Death or serious injuries upon explosion.
u Only use original spare parts for fan repair.
u
If the fan is made of conductive plastic, the spare part must be made of the
same material (PPs-el).
NOTICE Risk of damage due to prohibited spare parts
Component and material damage as well as production downtime.
▪ Loss of ATEX certification and void of warranty.
u
Only use original spare parts from the manufacturer for maintenance activi-
ties and repairs.
Order spare parts and wear parts from customer service (see title page) with the
following information:
• Type classification of fan according to nameplate or technical data sheet.
• Desired quantity.
• Specific designation
• of the spare part or wear part
_
Chap. 5.1 [
}
26],
• or of the option or accessory
_
Chap. 5.3 [
}
28].
Have the following spare parts and wear parts ready for impeller replacement:
Pc. Designation Spare part Wear part
1 Impeller X
1 Hub cap X
1 Hub adapter X
1 Sealing ring (inlet cover) X
1 Hub seal (option) X
12.4 Preparation for repairs
Prepare the fan for repairs (impeller, electric motor, hub seal, etc.) as follows:
1. Observe safety instructions
_
Chap. 11.1 [
}
60].
2. Switch off the fan and FC (option) and use the isolation switch to remove
voltage on all phases.
3. Secure the isolation switch with a personal padlock to prevent unauthorized
energization until completion of the repair work. Hang tag on isolation
switch.
4. Shut the shut-off damper to the supply air duct and discharge duct.
5. Drain condensate to condensate drain type K (option).