Coherent Solutions SwitchBlade, Руководство пользователя

Страница: 12 / 40

Modular Optical Switch | SwitchBlade
Coherent Solutions | SwitchBlade (V1.4) 8
7 Installing a SwitchBlade Expansion Module
W
ARNING
DO NOT attempt to remove or adjust any component of the MTP1000 while the
power is on. Make sure you follow the correct procedures below and power down
the MTP1000 first.
C
AUTION

Do not remove the SwitchBlade from the antistatic packaging until instructed
during the following installation procedure.

The SwitchBlade is sensitive to ESD. Please be sure to wear a grounded wrist
strap at all times when handling the SwitchBlade module to prevent such
damage.

Take care not to handle the connector on the SwitchBlade module once they
are exposed as this may leave corrosive residue which can damage the
connector.
Note : You will need a Phillips and Slot screwdriver to both unfasten the blanking module and secure the new
SwitchBlade module in place.
Power down the MTP1000
1. Press the Power On/Off switch. The switch will
no longer be illuminated indicating that the
instrument is off.
Figure 4 - Turn Off Power
Remove the blanking module
2. To remove the blanking module of the desired
slot, loosen the captive screws on the top and
bottom of the
blanking module . Do not attempt
to remove the screws completely as they are
designed to stay inside the front plate of the
module.
Figure 5 - Unfasten screw under Release Latch