Attach the belt clip by holding it
perpendicular, at a 90° angle, to
the printer. To remove the clip
depress the latch (A) and reverse
this operation. In normal use, the
printer will not unclip accidentally.
Contact Cognitive for other
accessories, including:
•
Shoulder strap
•
All-weather carrying case
Press Power (A) to turn the printer on. Press Feed (B)
to feed a label. The light (C) indicates:
•
Steady green: Label feeding or
printing, ready to print.
•
Slow blinking green: Power save
mode, ready to print.
•
Fast blinking green: Receiving data.
•
Green/red alternating: Printing a
test label, hex dump mode.
•
Red Blinking: Low battery.
•
No LED: Power off.
See Programmer’s Guide to adjust
the power-save modes.
IMPORTANT!
Charge the battery
for 12 hours prior to first use.Full
charging can take up to 12 hours
with the trickle charger or 2 hours
with the fast charger.
CHARGE & LOAD BATTERY
B
CABLE OPTION
2
IMPORTANT!
Do not use too much
force when attaching the strain relief
screw or risk damaging the printer
and/or clip.
TO OPEN:
Push UP the yellow tabs
(A) and pull the door out (B).
IMPORTANT!
The label imaging surface must be centered and face up. Latch
both sides of the door to ensure proper print quality.
A
B
LOAD MEDIA
TO CLOSE:
Press the front cover until
you hear the cover click. Press the
FEED button to position the label.
Lay the loose end of the media over
the center of the rubber roller.
A
C
B
BUTTONS & LIGHT
4
Remove several labels from the label backing. Open the peeler (A) and feed the
label
over the peelbar
and under the peeler mechanism (B). Center the label
backing and close the peeler.
PEELER OPTION
6
BELT CLIP & ACCESSORIES
5
TO REMOVE:
Depress the latch on
the back of the battery and slide the
battery forward.
A
1
3
A.)
Insert the cable (ordered separately)
into the strain relief clip.
B.)
Connect the RJ45 cable to the printer.
C.)
Attach the strain relief clip to the
top of the printer with the screw.
TO LOAD:
Slide the battery along
the bottom of the printer from front to
back until it clicks into place.
TO CHARGE:
Plug the charger (sold
separately) into a power outlet and
the DC plug into the battery jack (A).
C
B
A
TO LOAD:
Secure the media roll
between the guides.
A
A
