15m Breakout Cable (CCB-PWRIO-XX)
The Breakout cable provides access to trigger and high-speed outputs.You can clip unused wires short or use a tie
made of non-conductive material to tie them back. For RS-232, use the Power Supply return path for ground.
The figure on the left shows the plug on the device.
Acquisition Trigger
To trigger from an NPN type photoelectric sensor or PLC output, connect
Common In
to +24V and connect to the output
of the photoelectric sensor. When the output turns on, it pulls down to 0V, turning the opto-coupler on.
To trigger from a PNP photoelectric sensor or PLC output, connect to the output of the photoelectric sensor and connect
Common In
to 0V. When the output turns on, it pulls up to +24V, turning the opto-coupler ON.
67
Connections, Optics, and Lighting
