l
Press the trigger button on the reader.
l
Send a pulse on the I/O cable:
l
T (orange or red)
l
Trigger - (black)
l
Send a serial trigger command over the RS-232 connection connection.
l
Press <
CTRL-T
> on the keyboard while the DataMan Setup Tool has the input focus.
l
Click the
Trigger
button in the DataMan Setup Tool:
Training the Reader
Training your reader with the expected symbology can make the time required to decode successive symbols more
consistent. In addition, training may help increase decode yield.
To train your reader, place a code in front of the reader and do one of the following:
l
Press and hold the trigger button for a minimum of 3 seconds.
l
Click and hold the trigger button in the DataMan Setup Tool for a minimum of 3 seconds.
l
Click
Train Code
under
Actions
on the ribbon bar.
You can use training in
Single
,
Burst
,
Continuous
or
Self
trigger modes.
Note
: Only a single symbol of each symbology kind can be trained.
Training Feedback
The second LED from left on the reader glows green to indicate that it is currently trained, or yellow to indicate that it is
not trained.
Connect the reader to the DataMan Setup Tool to untrain it and allow it to recognize other enabled symbologies.
58
Using Your DataMan 370 Reader
