Note
: The flat side of the gasket (marked as "Front" in the image above) has to face outside.
WARNING
:
Do not touch any electrical component.
4. Reattach the I/O connector module to the main module.
5. Reinstall the washers and loosely fasten the modules together with the two T10 cap nuts, but do not tighten.
6. After each cap nut has been fastened, torque to 0.12 Nm (1.06 in-lb) and reinstall the screw covers.
Note
: There are unique left and right screw covers. Take care to attach them correctly.
Dimensions
The DataMan 260 consists of three main parts:
15
Getting Started