English
Each
ProSpot LX
utilises
16
channels of
DMX 512
signal for complete control.
DMX addresses
To ensure that each projector accesses the correct signal, it is necessary to correctly address each fixture. Any number
between 1 and 497 can be generated via the multifunction panel of the
ProSpot LX
.
This procedure must be carried out on every
ProSpot LX
being used.
When initially powered up, each projector will show
A001
indicating
DMX
address
1
. A projector thus addressed will
respond to channels
1
to
16
from the
DMX 512
controller; a second unit should be addressed as
17
, a third as
33
and
so on until the final
ProSpot LX
, has been addressed.
altering the dmx setting
1) Press the + or – buttons until the desired DMX address is displayed. The display will flash to indicate the selected address is not
stored in memory
2) Press the enter button to confirm your selection; the display will stop flashing and the projector will now respond to the
new DMX 512 setting.
3) To better understand the function of each channel, we refer you to 12 “DMX 512 channel functions”.
Important Note: Keeping the + or – buttons pressed will cause the display to alter at increased speed, allowing a faster selec-
tion to be effected.
AOO1
A 0 1 3
DMX 13 address
selection of new DMX 512 address that,
if not confirmed, it flashes for 6 seconds
before going back to default (to the
address previously recorded)
☞
+
o
–
A 0 1 3
The unit reacts to new
DMX 512 address
☞
enter
10. DMX addressing
