5.1. Operating voltage and frequency
The projector may operate at voltages of 208, 230 or 240VAC at a frequency of 50 or 60Hz.
Coemar
presets (barring specific requests) a
voltage of 240v at a frequency of 50Hz.. The preset voltage is indicated on the base of the projector.
5.2. Altering the operating voltage and frequency
(Reserved for technical personnel only)
If the factory preset operating voltage and frequency do not correspond to those in use in your country of operation, you may alter the
settings as described in the following paragraphs.
Loosen the screws on the cover of the base of the unit, as shown in the diagram below, using an appropriate screwdriver, thereby
removing the cover completely and allowing access to the internal components of the base of the
ProSpot 575 MB
.
Locate the transformer in the base of the unit.
Select a voltage from amongst 208, 230 or 240V by disconnecting cable n° 5 and moving it to the correct voltage. Refer to the sticker
located on the transformer to ensure the proper terminal is selected for your requriements.
Cable number 11 must not have its position altered under any circumstances
!
ATTENTION!!
Incorrect selection of operating voltage and frequency will seriously compromise the
functioning of the projector and will immediately void the warranty.
factory set
main at:
100V
115V
208V
230V
240V
50Hz
60Hz
5. Powering up
7
English