MBER
:
COMMUNICATION Error
This message indicates that the motherboard within the unit is not communicating properly with the control sour-
ce. Check the connectors located on both boards.
OPER
: PAN
ENCODER Error
This message indicates that there is a problem with the PAN encoders. Check the sensors on the encoder wheel
located near the pan movement motor, as well as the relevant cabling.
OTER
:
TILT ENCODER Error
This message indicates that there is a problem with the TILT encoder locate on the fixture yoke. Check the sensors
on the encoder wheel located near the pan movement motor, as well as the relevant cabling.
SNER
: SYNCHRONISATION
Error
Check and possibly replace the U9 opto-isolator.
EPER
: EEPROM
Error
The EEPROM is either defective or absent; refer to your coemar service centre for a replacement component.
DTER
: DATA Error
The initial parameter settings are incorrect or corrupt; the projector has reloaded its factory default settings. Turn
the projector off and on again. Should the error reoccur, refer the unit to your authorised coemar service centre to
have the EEPROM check and possibly replaced.
ADER
:
DMX ADDRESS Error
The projector is not receiving all DMX channels needed to operate correctly. Check the DMX address indicated on
the display and the channel numbers being outputted from the controller. Note that not all controllers will output
all 512 channels.
S1ER
:
Control circuit error relating to position sensors for 5 motors
Check for the presence of power to the PCB and the condition of the connectors and cabling between the PCB
and the sensors. Additionally, check motors and/or cogs for any impediments as well as the proper position of the
cabling connectors.
S2ER
:
Control circuit error relating to position sensors for 4 motors (located in the yoke at right when
viewed from the rear of the unit):
Check the cabling and the RESET sensors. Additionally, check motors and/or cogs for any impediments as well as
the proper position of the cabling connectors.
COER
:
COLOUR WHEEL POSITION Error
Check for correct functioning of the motor and the magnetic sensor and the correct positioning with respect to
the sensor and encoder wheel.
G1ER
:
GOBO WHEEL 1 POSITION Error
Check for correct functioning of the motor and the magnetic sensor of GOBO WHEEL 1
(wheel furthest from lamp).
G2ER
:
GOBO WHEEL 2 POSITION Error
Check for correct functioning of the motor and the magnetic sensor of GOBO WHEEL 2
(wheel closest to lamp).
R1ER
:
GOBO WHEEL 1 INDEXING Error.
Check for correct functioning of the motor and the magnetic sensor for gobo indexing
PRER
:
PRISM POSITION Error.
Check for correct functioning of the motor and the magnetic sensor of the prism.
FCER
:
FOCUSING LENSE POSITIONING Error.
Check for correct functioning of the motor and the magnetic sensor of the focusing lense.
ER20
÷
ER99
: SYSTEM Error
Turn the unit off and on again. If the error persists, contact your authorised coemar service centre.
14. Error messages
23
English