8.
Optional functions
The function of the
flash master
can be altered via the addition of a bridge (
P2
) to the circuit board within the
manual
system 6.
The button can generate a flash level as deternined by the 6 respective channel sliders or always at the maximum 100%.
To activate the bridge, proceed as follows:
1-Remove the 7 plastic slider knobs (6 channels & 1 master).
2- Loosen the screw on the
delay time
knob.
3- Loosen the 4 screws which affix the front panel to the controller housing.
4- Locate the bridge
P2
in the internals of the
manual system 6
(see diagramme).
5- Position the position of the bridge
P2
according to the function which you wish the
flash master
to perform (as described
below).
6- After selecting the position of the bridge
P2
, return the controller to its orignal state by replacing all components.
coemar
sets the
flash master
to its standard position as described in section
7.3
of this manual; bridge
P2
in in this case is
closed over contacts
2
and
3
.
The function of the
flash master
button can be altered if bridge
P2
is located over contacts
1
and
2
.
In this case the function is altered as follows:
In this setting it is possible to generate maximum output on all channels instantaneously.
Press the
flash master
button; the 6 channels output their maximum
level.
The leds above the respective sliders come on and remain on whilst
the button is held on.
The
delay time
potentiometer has no effect in this mode.
flash master
2-
The settings of sliders 1 to 6 has no effect on the action of the
flash
master
button.
Test this by relocating the sliders to a variety of positions.
4
3
2
1
6
5
0
10
20
30
40
50
60
70
80
90
100
10
1-
flash master
flash
1 2 3
P 2