AV control
Ordering code:
CKNPID1
AV control module is part of Your Cockpit system.
AV Control is an IR transmitter based on Z-Wave technology. It is
used for sending IR codes to infrared communication controlling
devices such as TV, DVD and TV box.
All non-battery-operated nodes within the network will act as
repeaters regardless of vendor to increase reliability of the
network.
AV Control is also a security Z-Wave device and supports the Over
The Air (OTA) feature for the product's firmware upgrade. If you
want your AV Control to be a security device that use secure/
encrypted message to communicate in a Z-Wave network, then a
security enabled Z-Wave controller is needed.
The features list:
1.
Z-Wave Plus certified for wide compatibility (500 serials product).
2.
Infrared max communication distance is about 12meters.
3.
Infrared emission angle is about 180
0
.
4.
Support firmware OTA.
1.
PRODUCT LAYOUT
2.
INSTALLATION
AV Control is simple to install and it should be installed near the
infrared devices as possible as you can.
1.
Utilize the screws provided to affix the plastic mount to the
surface you desired.
2.
After step 1, you can now lock your AV Control to the plastic
mount by pressing it as the direction shows below.
3.
Firmly connect the 5V/1A Micro USB adaptor to your AV
Control and then put the adaptor plug into an AC outlet. AV
Control will power on as soon as you plug in the adapter.
3.
INFRARED INFORMATION
Infrared emission angle has great effect on the communication
distance. The communication distance is up to 12 meters when the
angle between infrared device and AV Control is 90
0
(this is the
optimal performance). The communication distance is 3 meters
when the angle between infrared device and AV Control is 0
0
or
180
0
.
1.
The figure below shows the relation of Infrared emission angle
and Infrared communication distance.
2.
How to store infrared code on your AV Control.
You can learn infrared code from your remote. In the Cockpit
App put the AC control in learning mode, press the button you
want to configure and then press button on your remote control.
3.
How to control an infrared device.
After you store infrared codes on your AV Control, you can
control an infrared device via Cockpit App.
4.
Z-WAVE NETWORK INCLUSION
To include AV Control into a Z-Wave network as a non-security
device:
1)
Make sure the power supply is connected and the AV Control is
located within a direct Z-Wave network's main controller
communication range.
