16
10. MAINTENANCE AND CARE
Warning
:
Before performing any Maintenance or cleaning work, Always remove the battery
and switch off the isolator key!
Do not spray the unit with water. Ingress of water may destroy the switch-plug combination unit and the
electric motor. Clean the unit with a cloth, hand brush, etc.
Expert inspection is required, do not make any adjustment by yourself, must contact to customer
Service centre:
a) if the lawn mower strikes an object.
b) if the motor stops suddenly
c) if the blade is bent (do not align!)
d) if the motor shaft is bent (do not align!)
e) if a short-circuit occurs when the cable is connected.
f) If the V-belt is defective, where fitted.
h) Use only manufacturer’s recommended replacement parts and accessories.
11. TROUBLESHOOTING
Fault Remedial action
Motor does not run
Turn power on
Start on short grass or on an area which has already been mown.
Clean discharge channel/housing
–the mowing blade must rotate freely.
Correct the cutting height.
Motor power drops
Correct the cutting height.
Clean discharge channel/housing
Have mowing blade resharpened /replaced customer Service centre.
Grass catcher is not filled
Correct the cutting height
Allow the lawn to dry
Have mowing blade resharpened /replaced customer Service centre.
Clean the grille on the grass catcher
Clean the discharge channel /housing
Wheel drive does not function
(Power Drive Only)
Check the V-belt / gears customer Service centre.
Check the drive wheels for damage
Machine leaves ragged
finish
Height of cut too low, increase height of cut.
Cutting Blade Blunt, have the blade re-sharpened or replaced
Problem
Possible cause
Possible solution
Motor does not run
Power Turn off
Turn power on
Grass too long
Increase the height of cut and move
machine to shorter grass to start
Blade blocked
Clean discharge channel/housing
Machine leaves
ragged finish
Height of cut too low
Cutting Blade Blunt
Increase height of cut
Replace the blade
