COBIA 240 DC, Руководство пользователя

Страница: 9 / 38

9
Maverick Boat Group
3207 Industrial 29th St. • Fort Pierce, Florida 34946
(772)-465-0631
• cobiaboats.com
Fuel-Water Separator & Drain
Fuel-Water Separator
One Yamaha Fuel - Water Separator, two for twin
engines, is installed between the fuel tank and
engine on your 240 DC model. The new, improved
10-micron filter provides superior filtration ahead
of the engine's on-board filters and injectors. Large
filtering and water capture areas maximize
filtration while maintaining adequate flow rate for
larger engines. The fuel separator can be checked
by removing it from the mounting bracket and
dumping it into an approved waste collection device. If there appears to be an excessive
amount of water, the filter component should be replaced. See your authorized Cobia
Dealer for replacement parts.
Garboard Drain Plug
The garboard drain plug is the small metal plug located at
the lowest point on the hull, at the bottom of the transom
right above the keel. The drain has been designed so that it
can be loosened by hand while the hull is out of the water
for draining. This allows the plug to stay in contact with
the surrounding frame so you’l l never misplace or lose it. You can completely remove
the insert by pulling back and continue turning in a counter-clockwise motion. It is
manufactured with a rubber seal in place to ensure your bilge is watertight. Always
make sure before putting the boat in the water that this plug is hand tightened firmly.
Excess water in the bilge may be an indication of a problem with this plug or the
automatic bilge pump. Refer to the Water Drain System diagram on page 33.
Maintenance Note: Yamaha recommends replacing the 10-
micron fuel filter on new boats after the first 10 hours or 1 month of
operation and every 50 hours or every 6 months thereafter.
In
areas of high humidity where water in fuel supplies is a problem or
extensive engine operation occurs, more frequent replacement
may be necessary.
Fuel-Water Separator
Drain Plug