98-175666-C
D-1
Appendix D
Command line interface
D
D.1 Connection modes
After you have done the initial configuration and connected the SAILOR XTR to your
network, you can use SSH to configure the SAILOR XTR. You can also set up VSAT
modem parameters. Note that the following sections cover the command line
interface for all SAILOR XTR antennas.
Some of the commands may not be relevant for the antenna described in this manual.
SSH and Telnet connection
You can access the command line interface (UCLI) via SSH or Telnet. The UCLI interface
is available on the standard SSH port 22 or Telnet port 23.
Access to the SAILOR XTR system is protected by the password for the admin account.
This is the same password that is used in the web interface.
Use any BDU LAN port and corresponding IP address to get access to the UCLI. To start
an UCLI session do as follows:
1. Open an SSH or Telnet client of your choice.
2. Enter the IP address for the BDU LAN port, login user: admin and password for
admin account.
D.2 List of commands
The following commands are described in detail. They are listed in alphabetical order.
•
•
•
•
•
•
•
•
Important
Check that you have
Telnet access
enabled on the page
IoT &
Management
in the web interface.
Figure D-1: Command line interface, login
