COBHAM SAILOR 6110 mini-C GMDSS, Руководство по установке

Страница: 41 / 112

Chapter 3: Connect the system
The CAN backbone 29
3333
Co
nn
ec
t th
e
sy
st
em
3.3 The CAN backbone
When connecting the CAN backbone, be aware of the following
requirements:
• The CAN bus is already terminated with 120 Ohm inside the
SAILOR 3027.
You must provide the CAN bus with a termination
resistance of 120 Ohm
at the other end of the CAN backbone, either
with a separate termination resistance or inside the last device on the
CAN backbone.
• The cable length from each device to the CAN T-connector must be
maximum 6 m.
• The total length of the backbone must be maximum 200 m.
• Make the ground connection to ship ground (hull) at the power supply -
and only there.
• Connect the shield of the CAN cable to the connectors throughout the
system, but only connect to ship ground at the power supply.
Max.
6 m Max.
6 m Max.
6 m
Max. 200 m
120 Ohm
120 Ohm
here or
here GND
(ship hull)
Max.
6 m