COBHAM SAILOR 600 VSAT Ka, Руководство по установке

Страница: 22 / 178

SAILOR 600 VSAT Ka system
2-6 Chapter 2: Introduction 98-148248-A
2.1.3 Antenna Control Unit (ACU)
The ACU is the central control unit in the system. It contains all user interfaces and
manages all communication between the ADU and the connected modem, a connected PC
and an optional FleetBroadband service communication line. The ACU has a display, status
LEDs and a keypad. It provides a DHCP client. During configuration you can configure
heading offset, save satellite setups and enter
No Transmit Zones (blocking zones in which
the ADU does not transmit).
The user PC (user WAN) for Internet access etc. is connected to the ACU, not the modem.
The ACU provides DC power to the ADU through a single coaxial cable. You can use the
SAILOR 6080 AC/DC Power Supply to provide the DC power to the ACU. The ACU comes in
a 19” rack version.
You can do remote diagnostics and service with the ACU. Its built-in test equipment
constantly checks the device for proper functioning. It performs POST (Power On Self Test)
and you can request a PAST (Person Activated Self Test). Continuous Monitoring (CM) is
also available. BITE error codes can be read out in the web interface and in the display of
the ACU.
You can make a software update with a connected PC and the built-in web interface of the
ACU. The ACU has the following interfaces and switch:
• N-connector for ADU cable (50 Ohm).
• 2 x F connectors for Rx and Tx cables (75 Ohm) to modem.
• Multi connector for NMEA interfaces (for input from GPS compass or Gyro compass).
• RS-422 interface for BUC I/O.
Figure 2-6: Antenna Control Unit
Figure 2-7: ACU (connector panel)
/$1WRIURQW
7[,Q 5[2XW *URXQG /$1 56
10($
'&3RZHU
56 $QWHQQD
$&8
SAILOR600Ka-IM-98-148248.book Page 6 Monday, November 23, 2015 1:36 PM