COBHAM EXPLORER 8000 Series Скачать руководство пользователя страница 1

EXPLORER 8000 Series

Quick Guide

IMPORTANT

Observe all safety requirements listed in the 

beginning of the User & installation manual, 

and install and use the system according to the 

guidelines in the User & installation manual.
The 

User & installation manual

 is available in

• 

the web interface in the ACU (next section) 

• 

www.cobham.com/satcom

 (select 

Service 

and support > Cobham SATCOM Service 

and Support > Downloads

). 

Access the web interface

1. Switch on the Antenna Control Unit (ACU).
2. Connect your computer to 

LAN1

 on the back 

of the ACU, or your smartphone to the 

WLAN

 

interface of the ACU (WLAN must first be set 

up in the web interface using LAN1).

3. Open your Internet browser and enter the IP 

address of the ACU. The default IP address is 

http://192.168.0.1

.

4. On the ACU keypad, push and hold 

 for 5 

seconds and enter user name: 

admin

 (no 

password) in the web interface.  

Note: 

Change the administrator password 

immediately after login!

5. To access the 

User & installation manual

select 

HELPDESK > Support 

and click the 

link under 

User manual

.

Important! Calibrate the compass

You must make a compass calibration every time 

the antenna is installed. If the compass is not 

calibrated the system will not work properly! 
1. 

Park the car in a flat area and make sure the 

antenna is 

stowed

.

2. Switch on the ACU.
3. When the LEDs are steady green on the ACU, 

connect a computer to the ACU, access 
the web interface and go to 

SERVICE > 

Calibration

.

4. Under 

Compass calibration,

 click 

Start

.

5. 

When the Status field shows 

Ready

, move 

the vehicle to the next position, 90 degrees 
relative to the current position, and click 

Continue

6. When all four steps are completed, the 

Continue button changes to 

Start

. The 

compass calibration is now completed.

Start the system

1. Switch on the ACU and the VSAT modem. 
2. Wait until the LEDs on the front plate of the 

ACU show that the system is ready to be 

configured:

• 

Power LED: Green

• 

Logon LED: Off

• 

Fail/Pass LED: Flashing green during power-

on self test, after that steady green.

Отзывы: