COBHAM explorer 727, Руководство пользователя

Страница: 80 / 179

Chapter 4: To use the web interface
98-126882-F To set up the interfaces 73
To configure the Phone/Fax interface
To configure the Phone/Fax interface do as follows:
1. Select SETTINGS > Phone/Fax from the left navigation pane.
2. For each Phone/Fax port, set the call type for incoming and outgoing calls.
The call types are described in more detail in To select the call type on page 29.
• For Incoming calls , you can select Standard or 3.1 kHz Audio or both.
If you select both, any device connected to the Phone/Fax interface will react (ring) on
incoming calls.
If you select e.g. Standard, the Phone/Fax interface will only react on calls made to the
Standard phone number.
• For
Outgoing calls
, you can select either Standard or 3.1 kHz Audio. The selected type
will be used by default, if possible, for any outgoing call. Note, however, that fax
machines must use 3.1 kHz Audio.
3. For each port you can see whether or not Restricted dialing is enabled. For further
information, see Restricted dialing on page 129.
4. Click
Apply
.
Note
Port 1 is the connector closest to the antenna connector, and Port 2 is the
connector closest to the ISDN connector.
Note
You can override the default setting for outgoing calls: Dial 1* (force the call to
Standard) or 2* (force the call to 3.1 kHz Audio) before the number. For further
information, see
To override the default outgoing call type on page 29.