DIGIMINI EMEA/APAC/AUSTRALIA REPEATERS
PRODUCT DESCRIPTION AND USER’S MANUAL
Cobham Wireless
–
Coverage
Date: 11-Oct-15
www.cobham.com/wireless
Document number: 00030UMCD
Rev. 5.0
Page |
4-1
4 QUAD-BAND REPEATER INSTALLATION
This procedure describes how to assemble and install the DIGImini dual unit assembly supporting up
to four bands (quad-band). The assembly consists of two repeaters.
If your installation includes a
DMCU, only one DMCU is required for the complete quad-band assembly (two repeaters).
4.1 Overview
NOTE: The Donor and Mobile antennas can be positioned and installed (without being connected to a
Repeater) at any time either
before
or after
mounting
and grounding the Repeater.
1. Unpack the Repeater Tri/Quad-band kit.
2. Mount the wallmount bracket on the wall
3. Assemble the RF Combiners and Combiner Spacers onto the Quad-band brackets.
4. Using the supplied brackets, position the repeaters back to back on a flat surface and
interconnect the required interfaces as described in section
5. Pick-up the two-Repeater assembly and hang on the mounted wall bracket.
6. Mount the Power Supplies on the wall bracket (do not connect power).
7. Perform the required isolation and link tests.
8. Connect the antennas.
9. Power-on the Repeater.
10. For installations with a DMCU, mount the unit and refer to the DIGImini Single/Dual Band user
manual for detailed instructions.
