Keypad and menus of the BDU
98-175666-A
Chapter 4: Setup of the antenna
4-37
8.
TX
: <External Un-mute> <Modem TX allowed> <ADU TX allowed> <TX pol>
Read the TX status as follows: Upper case: Ok, lower case: Not ok, - unknown.
<External Un-mute> = [U,u], <Modem TX allowed> = [m,M], <ADU TX allowed> = [a,A]
<Tx pol>=[-,X,C]
After 1 hour the display is dimmed to lowest intensity. Press any key to light up the display.
Adjusting brightness of the display
To adjust the brightness do the following:
1. Press and hold
OK
for a short moment until BRIGHTNESS XXX% is displayed (XXX is the
current brightness value).
2. Hold OK p press
for lighter or
for darker display.
3. Release OK to leave the brightness menu.
Navigating the menus
Use the keypad to navigate the menus.
• Press
OK
or
to select a menu item.
• Use the arrow keys
and
to go through the menu items.
• Use the arrow keys
and
to go through the settings and move
from one digit to the next.
• Press
again to move one level up. If applicable, confirm to store the new setting by
pressing
OK
.
4.4.2 List of menus
The following tables show the main menu and submenus.
Top-level
Description
MAIN
View with current status of the SAILOR 1000 XTR Ka 4.5W.
This view is displayed after a time out of 10 minutes. Press any key (except
left arrow) to enter the menu at
MAIN
. New events are shown in this
display. If an event is displayed, press
OK
to jump directly to the menu
EVENTS
for viewing the currently active events.
ANTENNA
Shows the current ADU parameters, position, software version and serial
numbers of the ADU and BDU.
MODEM
Selected VSAT modem type and setup, including signal level.
NETWORK
Shows the IP addresses and netmasks of the LAN connectors of the BDU
and the management mask.
SATELLITE
Current satellite information. This information is entered using the web
interface.
EVENTS
View system events. Active events are shown as: X ACTIVE EVENTS in the
MAIN
display. Press
OK
to update the list.
Table 4-14: Top-level menus of the BDU
