To return units for repair
98-165591-B
Chapter 5: Service
5-18
5555
5.4.2
To stow the antenna manually
1. Make sure the power is switched off (or you have switched to Manual pointing).
2. Align the antenna positioner with the Base Unit.
3. Unscrew the cover for the elevation adjustment port.
Keep the cover for later.
4. Take out the adjustment tool.
(A plastic disc with a hex key, supplied with the Base Unit).
5. In the slot, locate the opening that matches the adjustment
tool. This is the elevation adjustment port, see picture.
6. Insert the adjustment tool and turn it clockwise to bring the
antenna reflector down to stowed position.
7. Take out the adjustment tool and remount the cover.
5.5
To return units for repair
Should your Cobham SATCOM product fail, please contact your dealer or installer, or the
nearest Cobham SATCOM partner. You will find the partner details on
Technical Service Partner List
. You can also access the
Cobham SYNC Partner Portal
https://sync.cobham.com/satcom
, which may help you
solve the problem. Your dealer, installer or Cobham SATCOM partner will assist you whether
the need is user training, technical support, arranging on-site repair or sending the product
for repair. Your dealer, installer or Cobham SATCOM partner will also take care of any
warranty issue.
Figure 5-18: Manual stow, elevation adjustment
Note
The position of the elevation adjustment port changes
depending on the elevation, so it may be located
elsewhere in the slot.
