To jog the antenna
98-165591-B
Chapter 4: Setup and operation
4-14
4444
4.6
To jog the antenna
You can use the Jog function to deliberately offset the antenna position. This is useful for
testing and troubleshooting and sometimes also during commissioning.
1. Connect a PC to the
Port 1
connector at the Base Unit.
You may also use WLAN, if it is configured.
2. Open an Internet browser and type the default IP address: http://192.168.0.1.
3. If the antenna is not already deployed, click
Deploy
in the top bar of the web interface.
4. Navigate to the page
SERVICE
>
Jog
and click
Activate Jog
.
5. When the status field shows
Jogging
, click the arrow buttons for Azimuth or Elevation
to change the offset, or type in specific values.
and
change the offset with 0.1° increments.
and
change the offset with 1.0° increments.
The current position as well as the offset is shown on the screen.
6. Select
Deactivate
to return to normal operation and reactivate the selected satellite
profile.
For information on the submenus
Modem
and
Antenna data
, see chapter 5,
Note
The antenna will not be transmitting, and you can enter any position
coordinates.
Figure 4-5: To jog the antenna using the web interface
Note
There may be slight deviations (or “random walk”) of a few tenths degrees.
