CS22 Owner’s Manual
3
-
35
O
PERATING
I
NFORMATION
COCKPIT TONNEAU COVER -
OPTIONAL
Follow these directions for the cockpit tonneau
cover.
1. Unroll the cover and snap to the deck, starting
at the center of the windshield. Snap to the
forward outside edge of the windshield only.
2. Install tonneau support pole(s) to underside of
the cover (just in front of rear seat) with snap
and adjust pole to approximate height of
windshield. Some models have two support
poles. Make sure the poles are perpendicular to
the floor and adjust to “tent” the cover.
3. Pull elastic cords over discs on transom,
starting in the center and working outboard (you
may have to readjust the support poles for
proper fit).
4. Continue snapping up the sides.
5. The walk-thru doors may be closed if desired.
Do not use cockpit tonneau cover for extended
storage. It is not designed for storage, but can be
used for overnight storage or trailering.
BIMINI TOP - OPTIONAL
1. Remove the stainless adjustable arms from the
storage area.
2. Unfold the top and install the stainless
adjustable arms (tensioners) into the
quick-disconnect fittings on the deck, forward of
the windshield. Secure the forward arms to the
forward cross members with the pins.
3. Tighten the bimini by twisting the tensioners.
Do not trailer with the bimini top up. Store and
trailer the bimini top in the stowed position, in its
canvas boot.
ECLIPSE ARCH W/BIMINI
1. Fold aft bimini bow toward the back of the boat.
2. Remove canvas boot.
3. Unfold canvas and deploy over the top of the
arch, and put the hole in the canvas over the
anchor light on top.
4. Move forward bimini bow to top quick release
position, and attach the short bimini poles to the
forward bow and quick release.
5. Unzip forward bow support pocket on the
canvas and put over forward bimini bow and
rezip canvas.
6. Pull the aft end of bimini down tight using
adjustable poles to hold tight.
NOTICE: Always double-check
snaps are secure.
COB_0138_A
COBAL
T
BOW TONNEAU
(BOW RIDERS ONLY)
COCKPIT
TONNEAU
NOTICE: Do not operate
equipment that has loose or
missing fasteners. Be sure all
fasteners are installed and
properly tightened before
operating equipment.
NOTICE: Do not operate
equipment that has loose or
missing fasteners. Be sure all
fasteners are installed and
properly tightened before
operating equipment.
Содержание CS22
