Cobalt Digital Inc BBG-1300-FR, Руководство по эксплуатации продукта

Страница: 21 / 46

BBG-1300-OM (V1.0) BBG-1300-FR PRODUCT MANUAL
2-5
Installation and Setup
Installing Rear I/O Modules and Cards
Network Connection
(See Figure 2-3.) Connect RJ-45 Ethernet network cable to rear panel
Ethernet connector. When the device is powered and connected to an active
network connection, basic connectivity is shown by illuminated indicators on
Ethernet receptacle.
Note: BBG-1300-FR must be configured to properly communicate with the card
remote control network (DashBoard and/or OGCP/WinOGCP devices). See
Setting Up Network Remote Control (p. 2-11) for instructions.
Reference Loop Connections
(See Figure 2-3.) A looping BNC pair is provided for a device REF loop.
Note: Looping reference connectors can receive ref input on either connector of the
looping pair. Unless daisy-chained to another node, an open connector here
must be terminated into an appropriate 75
Ω
terminator.
Installing Rear I/O Modules and Cards
Rear I/O Module Installation
In the mounting area corresponding to the slot location, install
Rear I/O Module as shown in Figure 2-4.
Note: • Only Standard-Width or Split Rear I/O Modules can be used with
BBG-1300-FR.
• For cards that have projecting sub-assemblies on the top (component) area
(such as daughtercards or fans), the card may not fit in the
typically-available top slot of BBG-1300-FR in conjunction with a
Standard-Width rear module. Ideally, these cards should be mated with a
rear module specified (on web page or manual) as:
Note: Mates to card in odd slot.
Odd-slot rear module places card mating in lower BBG-1300-FR slot and
circumvents top-clearance issue.